Neighbor Screen - ZyXEL Communications XGS1930-28 User Manual

Table 19 Status (continued)
LABEL
Cloud Control
Status
PoE Usage
Detail
IP Address Information
IPv4 Address
Subnet Mask
Default
Gateway
IP Setup
IPV6 Global
Unicast Address
IPV6 Link-Local
Address
IPv6
configuration
Device Status
and Quick
Configuration
Quick Links

7.2.1 Neighbor Screen

The Neighbor screen allows you to view a summary and manage the Switch's neighboring devices. It
uses Layer Link Discovery Protocol (LLDP) to discover all neighbor devices connected to the Switch
including non-Zyxel devices. You can use this screen to perform tasks on the neighboring devices like
login, power cycle (turn the power off and then back on again), and reset to factory default settings.
This screen shows the neighboring device first recognized on an Ethernet port of the Switch. Device
information is displayed in gray when the neighboring device is offline.
Click Status > Neighbor to see the following screen.
Chapter 7 Status
DESCRIPTION
This field displays the registration and connection status between the Switch and the NCC
(Nebula Control Center).
In Standalone mode, the status will display Disconnected or Unregistered. In cloud mode the
status will display Connected or Disconnected.
Connected – The Switch is registered with and connected to the NCC.
Disconnected – The Switch is not connected to the NCC.
Unregistered – The Switch is not registered with the NCC.
This field displays the amount of power the Switch is currently supplying to the connected PoE-
enabled devices and the total power the Switch can provide to the connected PDs. It also
shows the percentage of PoE power usage.
When PoE usage reaches 100%, the Switch will shut down PDs one-by-one according to the PD
priority which you configured in Basic Setting > PoE Setup.
Click this link to go to the Basic Setting > System Info screen to check other detailed information,
such as system resource usage and the Switch temperature, fan speeds or voltage.
This field displays the Switch's current IPv4 address.
This field displays the Switch's subnet mask.
This field displays the IP address of the Switch's default gateway.
Click the link to go to the Basic Setting > IP Setup screen.
This field displays the Switch's IPv6 global unicast address
This field displays the Switch's IPv6 link-local address.
Click the link to go to the Basic Setting > IPv6 screen.
This section shows whether a feature is enabled or not on the Switch. You can click a feature's
Setting link to go to the configuration screen for the feature.
Hover your cursor over a red exclamation mark to display information about the feature.
This section provides the shortcut link to a specific configuration screen.
XGS1930 Series User's Guide
76