Mac Count Screen - ZyXEL Communications MSC1000G User Manual

Chapter 4 Access Control List Screens

4.7 MAC Count Screen

This screen allows you to limit how many MAC addresses may be dynamically learned on a DSL port
or Gigabit Ethernet port.
Note: You cannot enable both MAC count and MAC filtering on the same port at the same
time.
Click ACL > MAC Count to display the screen shown next.
Figure 39 MAC Count
The following table describes the labels in this screen.
Table 23 MAC Count
LABEL
Slot
Port
VPI VCI
Load
Enable
98
DESCRIPTION
Use the drop-down list boxes to select an DSL port or Gigabit Ethernet port on a line card
for which you want to configure the MAC count limit.
For a line card that supports MAC count by PVC, type the Virtual Path Identifier and Virtual
Circuit Identifier for a channel on the port.
Click Load to display the port's current settings.
Select the check box to activate the MAC count limit on the specified DSL port.
You can only enable the MAC count filter on DSL ports that do not have the MAC filter
enabled.
Management Switch Card User's Guide