Pppoe Screen - ZyXEL Communications MSC1000G User Manual

Chapter 4 Access Control List Screens

4.19 PPPoE Screen

Use the ACL > PPPoE screen to configure PPPoE line information setting by VLAN. The switch adds
the line information to PPPoE packets for identification and security.
Figure 57 ACL > PPPoE
The following table describes the labels in this screen.
Table 40 ACL > PPPoE
LABEL
VID
Enable
Option Mode
Info
Apply
New
Cancel
Index
VID
Enable
Option Mode
Info
122
DESCRIPTION
Enter a VLAN ID (between 1 and 4094).
Turns PPPoE line information for the VLAN on or off.
Select private to use ZyXEL's proprietary method to encode PPPoE discover packets on the
specified VLAN.
Select tr101 to use TR-101 to encode PPPoE discover packets on the specified VLAN.
Select tr101 to use TR-101 to encode PPPoE discover packets on the specified VLAN and
include the VLAN ID.
See Section 4.1.1 on page 81
Specify (up to 24 characters) of PPPoE line information.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click New to clear the fields so you can create a new entry.
Click Cancel to begin configuring this screen afresh.
This is the index number of an entry.
This is the ID number of the VLAN group.
This field displays whether or not encoding of PPPoE line information in the VLAN's PPPoE
discover packets is turned on.
This field displays the type of encoding for PPPoE line information in the VLAN's PPPoE
discover packets.
This field displays the PPPoE line information.
for more on these modes.
Management Switch Card User's Guide