ZyXEL Communications MSC1000G User Manual page 287

Figure 183 The Port > VoIP SIP Setup > SIP Port Setup Line Card Screen
The following table describes the labels in this screen.
Table 130 The Port > VoIP SIP Setup > SIP Port Setup Line Card Screen
LABEL
UP
Copy
Apply
Cancel
Port
Management Switch Card User's Guide
DESCRIPTION
Click this to return to the Port > VoIP SIP screen.
Use this to assign the selected port's settings to other ports.
1. Click Copy. The following pop-up screen displays.
Figure 184 Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select All to select
every port. Use Select None to clear all of the check boxes.
4. Click Apply to copy the settings, or click Cancel to close the window without
saving any changes.
Click this to save your changes to the MSC's volatile memory. The MSC loses these
changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click this to begin configuring the fields again.
These are the numbers of the line card's ports.
Click a port number to display the Advanced SIP Port Setup screen (see
9.24 on page 288).
Chapter 9 Subscriber Port Setup Screens
Section
287