ZyXEL Communications MSC1000G User Manual page 108

Chapter 4 Access Control List Screens
Table 29 Packet Filter (continued)
LABEL
EAPOL Filter
Out
IGMP Filter Out Internet Group Management Protocol is used when sending packets to a specific group of
Apply
Cancel
Copy
ID
State
Card Type
Up Time
Firmware
108
DESCRIPTION
EAP (Extensible Authentication Protocol, RFC 2486) over LAN. EAP is used with IEEE 802.1x
to allow additional authentication methods (besides RADIUS) to be deployed with no
changes to the access point or the wireless clients.
hosts.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to display
the Packet Filter Slot screen where you can view and copy settings from one port to
another port or ports on the selected line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to
the card starting, a firmware upgrade in progress or a malfunction. See
1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was started.
This field displays the current firmware version installed on the line card.
Section 38.7 on page
Management Switch Card User's Guide