Shdsl Port Setup Line Card Screen - ZyXEL Communications MSC1000G User Manual

Table 111 SHDSL Port Setup (continued)
LABEL
Copy
ID
State
Card Type
Up Time
Firmware

9.10.1 SHDSL Port Setup Line Card Screen

Click Port > SHDSL in the navigation panel to open the SHDSL Port Setup screen. Click the slot
number of an active SHDSL line card to open the following screen. Use this screen to configure
settings for individual SHDSL ports and copy settings between ports.
Management Switch Card User's Guide
DESCRIPTION
Do the following to copy DSL settings from one DSL port to another DSL port or ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the number
of the DSL port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 157 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
This column lists the slot numbers of the line cards. Click the ID number of an active
SHDSL line card to go to a screen where you can copy an SHDSL port's settings to
another SHDSL port.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
page 1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
Chapter 9 Subscriber Port Setup Screens
Section 38.7 on
251