Port Enet Flowctrl Enable Command - ZyXEL Communications MSC1000G User Manual

29.10.7 port enet flowctrl enable Command

Syntax:
port enet flowctrl enable <slot-port>
This command turns on flow control on an Ethernet (ELC) subscriber port.
The following example turns on the flow control on port 5 on the ELC in slot 4.
ras> port enet flowctrl enable 4-5
29.10.8 port enet frametype Command
Syntax:
port enet frametype <slot-port> all|tag
where
all|tag =
This command sets the specified Ethernet (ELC) subscriber port(s) to accept all Ethernet frames or
only those with an IEEE 802.1Q VLAN tag.
The following example sets port 5 on the ELC in slot 4 to accept only tagged frames.
ras> port enet frametype 4-5 tag
29.10.9 port enet priority Command
Syntax:
port enet priority <slot-port> <priority>
where
<priority>
This command sets the default ingress user priority of the specified Ethernet (ELC) subscriber
port(s).
The following example sets the default priority of port 5 on the ELC in slot 4 to 3.
ras> port enet priority 4-5 3
Management Switch Card User's Guide
Specifies all Ethernet frames (tagged and untagged) or only tagged Ethernet
frames.
=
The default ingress priority (0~7). 0 is the lowest priority level and 7 is the
highest.
Chapter 29 port Commands
789