Ip Show Command - ZyXEL Communications MSC1000G User Manual

25.2.8 ip show Command

Syntax:
ras> ip show
Use the command to display the current management IP settings. An example is shown next.
ras> ip show
interface
--------- --------------- --------------- ----
inband
outband
gateway: 123.23.15.254
25.2.9 ip set Command
Syntax:
ras> ip set inband|outband <ip-address>[/<netmask>] [<inband-vid>]
where
inband
outband
[<inband-
vid>]
This command sets the system's IP addresses and in-band management VLAN (CPU). You can only
manage the system through ports that are members of the management VLAN.
Note: By default, you can access the management VLAN from all of the IES's in-band
ports since they are all in the management VLAN. If you need more security, please
see the following example.
25.2.9.1 Configuring Management VLAN Example
Note: After the following example configuration, you must connect through the third
Ethernet port (uplink port 1) in order to perform inband management. You must
connect through a VLAN aware device that is using the proper VLAN ID in order to
perform management.
Another option would be to set the PVID of the third Ethernet port to 3, but this is not
recommended since all Ethernet frames received on the port without a VLAN tag would be
considered part of VLAN 3.
By default, the DSL ports are members of the management VLAN (VID 1). The following procedure
shows you how to configure a tagged VLAN that limits management access to just one Ethernet
port.
Management Switch Card User's Guide
interface ip netmask
192.168.1.2 255.255.255.0
123.23.15.86 255.255.255.0
=
Sets the in-band management IP address.
= Sets the out-of-band management IP address (for the MGMT port).
= Sets the VLAN ID (Identifier) of the management (CPU) VLAN. You must connect
to the system through a port that is a member of the management (CPU) VLAN in
order to perform in-band management.
vid
1
-
Chapter 25 ip Commands
725