The H248 Port Setup Screen - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
Table 131 The Advanced Port SIP Setup Screen
LABEL
Apply
Cancel

9.25 The H248 Port Setup Screen

Use this screen to manage and configure the VoIP settings of each port on your H.248 line card(s).
Click Port > VoIP H248. The following screen displays.
Figure 186 Port > VoIP H248 Screen
The following table describes the labels in this screen.
Table 132 Port > VoIP H248 Screen
LABEL
Slot
Port
Load
Enable
290
DESCRIPTION
Click this to save your changes to the MSC's volatile memory. The MSC loses these
changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click this to begin configuring the fields again.
DESCRIPTION
Use the drop-down list boxes to select the port on an active VoIP line card you want
to configure.
Click this to display the port's current settings.
Select the check box to activate H.248-based VoIP on the specified port.
Management Switch Card User's Guide