ZyXEL Communications MSC1000G User Manual page 158

Chapter 5 Alarm Screens
Table 60 Alarm Descriptions (continued)
ALARM
CLI_SYNC_PROF_OK
CLI_SYNC_PROF_FAIL
ANTI_SPOOFING
PING_PROBE_FAIL
PING_TEST_FAIL
PING_TEST_COMPLETE
TRACERT_TEST_FAIL
TRACERT_TEST_COMPLET
E
Ethernet
ENET_UP
ENET_DOWN
ENET_LOOPGUARD
ENET_SFP_ERROR
ENET_SFP_TX_ENABLE
ENET_SFP_TX_DISABLE
VoIP
VOP_TEMP_ERROR
VOP_DC_POWER_FAIL
VOP_AC_POWER_FAIL
VOP_RING_TIMER_FAIL
VOP_RING_RSRCE_FAIL
VOP_RING_OHD_FAIL
VOP_NO_FREE_DSP_CHAN
NEL
VOP_MC_MISSING
158
SEVERITY MSC ALC SLC VLC VOP IMA DESCRIPTION
INFO X
INFO X
Minor X
INFO X
INFO X
INFO X
INFO X
INFO X
INFO X
MINOR X
MINOR X
MAJOR
INFO
INFO
CRITICAL
CRITICAL
CRITICAL
CRITICAL
CRITICAL
INFO
INFO
CRITICAL
Client-initiated profile synchronization is
successful.
Client-initiated profile synchronization
failed.
A system connected to the MSC detected
a MAC address connected to more than
one port.
A continuous ping test via diagnostic tool
is failed.
A ping test via diagnostic tool is failed.
A ping test via diagnostic tool is
completed.
A trace route test via diagnostic tool is
failed.
A trace route test via diagnostic tool is
completed.
An MSC Gigabit Ethernet interfaces is
up.
An MSC Gigabit Ethernet interfaces is
down.
A network loop has been detected.
An MSC SFP transceiver has errors.
A fiber optic transmission on the MSC is
enabled.
A fiber optic transmission on the MSC is
disabled.
X A SLAC thermal fault has been detected
on a VOP card's.
X A SLAC DC fault has been detected on a
VOP card's telephone line.
X A SLAC AC fault has been detected on a
VOP card's telephone line.
X A VOP card's ring timer failed.
X Too many ports are ringing, so there was
not enough ring power to ring the phone
connected to this port.
X A ring overload indication has been
detected. A VOP card is close to using its
full ring power and will reduce the ring
output power if the load continues to
increase.
X A VOP card's DSP channels were all in
use so the VOP was not able to handle
another call. This could be caused by the
VOP card's DSP processing many
conference calls.
X The signaling VOP card cannot detect the
media VOP card.
Management Switch Card User's Guide