Profile Commands - ZyXEL Communications MSC1000G User Manual

This chapter shows you how to use the
30.1 Profiles Overview
Profiles are groups of settings that you can assign to a port(s). This helps simplify and speed up port
configuration.
30.2 General profile Command Parameters
The following table describes commonly used
Table 365 General profile Command Parameters
NOTATION
profile
Management Switch Card User's Guide
C
profile
DESCRIPTION
The profile name, up to 31 characters.
Alarm profile settings
: near end
atuc
: far end
atur
The maximum time there is loss of framing (0~900 seconds).
lofs:
The maximum time there is a loss of signal (0~900 seconds).
loss:
The maximum time there is a loss of link (0~900 seconds).
lols:
The maximum time there is a loss of power (0~900 seconds).
lprs:
The maximum time there is error (0~900 seconds).
ess:
The maximum time there are failed fast retrains (0~900 seconds).
ffr:
The maximum time there are severe errors on the line (0~900 seconds).
sesl:
The maximum time there the line is unavailable (0~900 seconds).
uasl:
The maximum transmission rate (0~2147483 Kbps).
fru:
The maximum interleave rate (0~2147483 Kbps).
iru:
The minimum transmission rate (0~2147483 Kbps).
frd:
The minimum interleave rate (0~2147483 Kbps).
ird:
Enables (1) or disables (0) the init failure trap.
ift:
HAPTER

profile Commands

commands.
command parameter notation.
profile
3 0
841