G.bond Screen - ZyXEL Communications MSC1000G User Manual

Table 127 IPB Route (continued)
LABEL
Cancel
Domain
Index
Route IP
NetMask
Nexthop
Metric
Change Pbit
Select
Modify
Delete

9.21 G.bond Screen

G.bond (also known as port bonding) allows subscribers to connect to an ISP using data streams
spread over multiple DSL lines. The total available bandwidth for the subscriber then becomes the
sum of the bandwidth available for each of the subscriber's line connections. As well as extra
bandwidth, additional DSL lines also provide backup support.
Your system supports port bonding on certain line cards. The ALC1248G-51, ALC1272G-51,
ALC1372G-51, and ALC1348G-51C support ADSL port bonding for connecting to ZyXEL's P-663H-
51. The SLC1248G-22 and SLC1348G-22 support SHDSL port bonding for connecting to ZyXEL's
IES-708-22A. See the IES-708-22A's User's Guide for information on its port bonding specifications.
The VLC14xx, VLC1324G-51/53 and VLC1348G-51/53 line cards support VDSL port bonding for
connecting to ZyXEL's VMG4325-B10A.
The next figure shows a subscriber using port bonding on two DSL lines between a P-663H-51 (A)
(using a Y-connector) and an ADSL line card in the IES (B) to connect to the Internet.
Management Switch Card User's Guide
DESCRIPTION
Click Cancel to start configuring this section of the screen again.
The bottom section displays routing table entries created manually. It does not show entries
added automatically by the MSC. See
table(s) for selected domain(s).
Select a domain for which you wish to view information and click Load to display it.
This field displays the number of the entry.
These fields display the IP address and the number of bits in the subnet mask that define the
range of IP addresses to which this entry applies. If the destination IP address of a packet is in
this range, the MSC forwards the frame to the specified edge router.
This field displays the IP address to which the MSC forwards frames if the destination IP
address of a packet is in the specified range.
This field displays the "cost" of transmission for routing purposes.
If you set the MSC to change the IEEE 802.1p priority value of incoming frames, this field
displays the priority value (0 to 7) to which the MSC sets them. "-" displays if you do not set
the MSC to change the IEEE 802.1p priority value of incoming frames.
Select the radio button in the Select column for an entry and click Modify to be able to edit the
entry or Delete to remove it.
Chapter 9 Subscriber Port Setup Screens
Section 12.9 on page 422 to look at the full routing
279