ZyXEL Communications MSC1000G User Manual page 298

Chapter 9 Subscriber Port Setup Screens
Figure 193 ENET Port Setup: Line Card
The following table describes the fields in this screen.
Table 136 ENET Port Setup: Line Card
LABEL
UP
Copy
Apply
Cancel
Port
Enable
298
DESCRIPTION
Click this to return to the previous screen.
Do the following to copy settings from one Ethernet port to another Ethernet port or ports.
1. Use the Select column to choose an Ethernet port from which you want to copy
settings.
2. Click Copy to open the following screen.
Figure 194 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
These are the numbers of the subscriber ports on the line card.
To configure advanced port settings, click a port number to display the ENET Port Setup
screen.
Select a check box in this column to turn on a port. Select the check box at the top of the
column to turn on all of the line card's ports.
Management Switch Card User's Guide