Port Ipbpvc Show Command - ZyXEL Communications MSC1000G User Manual

Chapter 29 port Commands
<type>
This command allows the configuration of a PVC (permanent virtual circuit) for one or a range of
ADSL ports in an IP bridge.
The following example sets a PVC on slot 1, DSL port 10 with VPI 40, VCI 73, DEFVAL profile,
default VID 402 and priority 2. It uses LLC encapsulation over Ethernet.
ras> port ipbpvc set 1-10-40/73 DEFVAL 402 2 llc
ras> port ipbpvc show 1-10
pvc
--------------- ------- ---- --- ---------- --------------------------------
--
1-10-40/73

29.22.5 port ipbpvc show Command

Syntax:
port ipbpvc show <slot>|<slot-port>|<slot-port-vpi/vci>
where
vpi/vci
This command allows you to display the PVCs for subscribers in an IP bridge.
An example is shown next.
ras> port ipbpvc show 1-10
pvc
--------------- ------- ---- --- ---------- --------------------------------
--
1-10-40/73
The output values correspond to the input values of other IP bridge PVC commands.
29.22.6 port ipbpvc vlan Command
Syntax:
port ipbpvc vlan <slot-port-vpi/vci> <vid> <registration> <tag>
where
vpi/vci
806
Specify the encapsulation type for the PVC.
=
llc and vc are for a PVC running on Ethernet (IPoE).
llc_r and vc_r are for a PVC running on ATM (IPoA).
type pvid pri ipbpvctype profile
ipb 402 2
The VPI and VCI of an individual PVC.
=
type pvid pri ipbpvctype profile
ipb 402 2
The VPI and VCI of an individual PVC.
=
llc DEFVAL
llc DEFVAL
Management Switch Card User's Guide