Switch Bandwidth Commands - ZyXEL Communications MSC1000G User Manual

Table 386 switch Commands (continued)
COMMAND
vcc
vlanpri disable
enable
delete
set
show

33.4 switch bandwidth Commands

Use the
switch bandwidth
33.4.1 switch bandwidth disable Command
Syntax:
switch bandwidth enable <giga-port>
where
<giga-port>
This command turns on bandwidth control on the specified Gigabit Ethernet interface (or all of
them).
This example turns off bandwidth control for the uplink 1 port.
ras> switch bandwidth disable up1
33.4.2 switch bandwidth enable Command
Syntax:
switch bandwidth enable <giga-port>
Management Switch Card User's Guide
<giga-
port>|<slot-port>
<high-limit> <low-
limit>
<vid>
<vid> <priority>
[vid]
commands to configure bandwidth control.
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports. Use
sub1|sub2|up1|up2|all i
if trunking is enabled.
Chapter 33 switch Commands
DESCRIPTION
Sets a transceiver's voltage thresholds. When the
value goes out of the thresholds, the system
sends an alarm.
high-limit: high threshold, 0~6.5535
low-limit: low threshold, 0~6.5535. The value
must be smaller than the high-limit value.
Turns off assigning of priority to traffic based on
its VLAN.
Turns on assigning of priority to traffic based on
its VLAN.
Removes the VLAN-based priority setting for the
specified VLAN ID.
Has the system assign the specified priority to
traffic with the specified VLAN ID.
Displays the current setting for VLAN-based
priority or the VLAN-based priority setting for a
specific VLAN ID.
f trunking is not enabled. Use
P
8
8
8
8
8
1
sub|up|all
991