Show Igmp Commands - ZyXEL Communications MSC1000G User Manual

Chapter 32 show Commands

32.3.12 show igmp Commands

Use the show igmp commands to display current IGMP settings and statistics. Use
igmp enable
32.3.12.1 show igmp info Command
Syntax:
show igmp info
This command displays the current IGMP settings and the number of IGMP-related packets
received. The following figure shows an example.
ras> show igmp info
mode is igmpsnooping
number of queries
number of reports
number of leaves
number of unknowns = 0
number of groups
ras>
32.3.12.2 show igmp group Command
Syntax:
show igmp group [<vid> <mcast_ip>]
where
<mcast_ip>
This command displays the IGMP group information that is learned on the system or from the
specified VLAN.
ras> show igmp group
[multicast group info]
vid multicast group port
---- --------------- -------------------- ---------------- --------------
ras>
32.3.12.3 show igmp port info Command
Syntax:
show igmp port info <slot-port>
948
to enable IGMP first.
= 0
= 0
= 0
= 0
=
The multicast IP address.
slot timestamp
Management Switch Card User's Guide
multicast