ZyXEL Communications MSC1000G User Manual page 1037

Table 387 sys Commands (continued)
COMMAND
server enable
disable
port
show
snmp getcommunity
setcommunity
show
trapcommunit
y
trapdst
user
version
syslog disable
enable
server
show
session loginmsg
show
Management Switch Card User's Guide
DESCRIPTION
Turns on service access to the switch.
telnet|ssh|ftp|web
|icmp|snmp|https
Turns off service access to the switch.
telnet|ssh|ftp|web
|icmp|snmp|https
Sets a port for a service.
telnet|ftp|web|snm
p|ssh|https <port>
Displays service access control settings.
Sets the SNMP GetRequest community.
<community>
Sets the SNMP SetRequest community.
<community>
Displays SNMP settings.
Sets the SNMP Trap community.
<community>
Sets the IP addresses and listening ports for up to
<index>
four SNMP trap server IP addresses and listening
<destination>
ports. Set 0.0.0.0 to not send any SNMP traps.
[<port>]
[v1|v2c|v3]
name:
[<name>] Only applicable for V3.
Sets SNMPv3 user name and security settings.
<name>
noauth|auth|priv
noauth
md5|sha des|aes
encryption.
auth
pri
encryption.
md5|sha
des|aes
Sets the system to use the specified SNMP version
v2c|v3|v3v2c
and access.
v2c
v3
v3v2c
only.
Turns off syslog logging.
Turns on syslog logging.
Sets the log facility (local1~local7) to log the
<fac> <ip-address>
syslog messages to a specific file in the syslog
server. See your syslog program's documentation
for details. Sets the syslog server IP address.
Displays the syslog settings.
Enter a mode that lets you specify a note to
display when users attempt to log into the
system's management interfaces.
Displays the session timeout setting and the login
message.
Chapter 34 sys Commands
username to be included in trap packets.
: disables user authentication and data
: enables user authentication.
: enables user authentication and data
: authentication method.
: encryption method.
: SNMPv2 read/write
: SNMPv3 read/write
: SNMPv3 read/write and SNMPv2 read-
P
8
8
8
1
8
8
1
8
8
8
8
8
8
8
1
14
1
1037