ZyXEL Communications MSC1000G User Manual page 1036

Chapter 34 sys Commands
Table 387 sys Commands (continued)
COMMAND
date set
show
info chassis
contact
frame
hostname
location
show
monitor set
show
multilogin disable
enable
privilege set
show
show
reboot
[show|sec|ca
ncel]
1036
DESCRIPTION
Sets the system date.
<yyyy> <mm> <dd>
Displays the current system date.
Sets the system chassis number (1~64).
<chassis>
Sets contact person information.
<contact>
Sets the system frame number.
<frame>
Sets the system name.
<hostname>
Sets the geographic location of the system.
<location>
Displays general system and system information.
Sets hardware monitor alarm thresholds.
<slot>
<volt|temp|fan|cpu
volt: Voltage
|mem|pbuf> <index>
index: 1~5 (the number of voltage sensors varies
<high-limit> <low-
by card)
limit>
temp: temperature
index: 1~3
fan: for system FAN,
index: 1~6 (the number of fans varies by
chassis)
cpu: CPU
index: 1
mem: Memory
index: 1
pbuf: Packet buffer for transmission and receiving.
index: 1
Displays the hardware monitor threshold settings
<slot>
of a slot.
Turns off multiple concurrent logins.
Turns on multiple concurrent logins.
Sets the privilege level required to execute all
[all] <privilege>
commands or a specific command. See
<command>
37.6 on page 1101
permit on the TACACS+ server to allow various
FTP actions.
Displays the privilege level required to execute all
<command>
commands or a specific command.
Displays the multiple login setting.
Restarts the system.
show: Displays the reboot schedule.
sec: Sets the number of seconds (1~2147483647)
before the system reboots. If there is no time
specified, the system reboots immediately.
cancel: Aborts the scheduled system rebooting.
Section
for the command strings to
Management Switch Card User's Guide
P
8
1
8
8
8
8
8
1
8
1
8
8
14
1
1
14
8