ZyXEL Communications MSC1000G User Manual page 213

Table 94 ADSL Port Setup (continued)
LABEL
Mode
ADSL Profile
Alarm Profile
Customer
Information
TEL
Advanced Feature
Apply
Cancel
Copy
Management Switch Card User's Guide
DESCRIPTION
Select the port's ADSL operational mode. Select the mode that the subscriber's device
uses or auto to have the system automatically determine the mode to use. See
on page 205 for information on the individual ADSL modes.
Select a profile of ADSL settings (such as the transfer rate, interleave delay and signal to
noise ratio settings) to assign to this port. Use the ADSL Profile screen to configure
ADSL port profiles.
Select an alarm profile to define the thresholds that trigger an alarm on the port when
exceeded.
Enter information to identify the subscriber connected to this ADSL port. You can use up
to 31 printable English keyboard characters (including spaces and hyphens).
Enter information to identify the telephone number of the subscriber connected to this
ADSL port. You can use up to 15 English keyboard characters (including spaces and
hyphens).
For ADSL line cards, you can select a port and click the Setup button to open a screen
where you can configure the ADSL port's detailed settings. See
for more information.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy DSL settings from one DSL port to another DSL port or ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the number
of the DSL port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 130 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Chapter 9 Subscriber Port Setup Screens
Section 9.7.2 on page 216
Table 87
213