ZyXEL Communications MSC1000G User Manual page 246

Chapter 9 Subscriber Port Setup Screens
Table 109 Port > VDSL2 (continued)
LABEL
Queue Schedule
Customer
Information
TEL
Frame Type
PVID / Priority
VLAN
PVLAN
XVLAN
Apply
Cancel
246
DESCRIPTION
Set the port's Class of Service (CoS) scheduling method.
Select SPQ to use Strict Priority Queuing to service queues based on the traffic's IEEE
802.1p priority only. When the highest priority queue empties, traffic on the next highest-
priority queue begins.
Select WRR to use Weighted Round Robin (WRR) scheduling to service queues on a
rotating basis based on their queue weight (the number you configure in the queue weight
fields). Queues with larger weights get more service than queues with smaller weights.
If you select WRR, use the Q0 to Q7 fields to set the priority weight (0~15) of each IEEE
802.1p priority queue. The higher a queue's weight, the more service it gets.
Enter information to identify the subscriber connected to this DSL port. You can use up to
31 printable English keyboard characters (including spaces and hyphens).
Enter information to identify the telephone number of the subscriber connected to this DSL
port. You can use up to 15 English keyboard characters (including spaces and hyphens).
Specify the type of frames allowed on a port. Choices are All and Tag Only.
Select all from the drop-down list box to accept all untagged or tagged frames on this port.
This is the default setting.
Select tag to accept only tagged frames on this port. All untagged frames will be dropped.
Specify the port VLAN ID (1~4094) and IEEE 802.1p priority (0~7) to add to untagged
frames received on this port. If an untagged frame matches a PVLAN setting, the system
uses the PVLAN setting instead.
Click the Setup button to open a screen where you can configure the VLAN settings for the
VDSL port. See Section 9.8.8 on page
Click the Setup button to open a screen where you can configure Protocol VLAN (PVLAN)
settings for the VDSL port. See
Click the Setup button to open a screen where you can configure VLAN translation settings
for the port. See Section 9.8.10.1 on page
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
238.
Section 9.8.9 on page 240.
242.
Management Switch Card User's Guide