Ipv6 Setup - ZyXEL Communications MSC1000G User Manual

14.6 IPv6 Setup

Click Sys > IP Setup from the navigation panel and then IPv6 to open the following screen. Use
this screen to configure the system and management IP addresses and subnet masks.
Figure 393 IPv6 Setup
The following table describes the labels in this screen.
Table 306 IPv6 Setup
LABEL
Default
Management
Inband
IP Address
Prefix
VID
Outband
IP Address
Prefix
Default Gateway
Apply
Cancel
Management Switch Card User's Guide
DESCRIPTION
Select Inband to connect to the network port's IPv6 address to access the management
interface.
Select Outband to connect to the management port's IPv6 address to access the
management interface.
These fields configure in-band management settings. In-band management refers to
accessing the management interface through a network port (not the management port).
Enter the in-band management IPv6 address for the system in dotted decimal notation
(for example 1.2.3.4).
Enter the prefix length for this IPv6 address if you want to use a static IP address. This
field is optional. The prefix length indicates what the left-most part of the IP address is
the same for all computers in the network, that is, the network address.
Enter the VLAN ID (Identifier) of the management (CPU) VLAN. You must connect to the
system through a port that is a member of the management (CPU) VLAN in order to
perform in-band management.
These fields configure out-of-band management settings. Out-of-band management
refers to accessing the management interface through a management port.
Enter the out-of-band management IPv6 address for the management port in dotted
decimal notation (for example 1.2.3.4).
Enter the prefix length for this IPv6 address if you want to use a static IP address. This
field is optional. The prefix length indicates what the left-most part of the IP address is
the same for all computers in the network, that is, the network address.
Enter the IPv6 address of the default outgoing gateway in dotted decimal notation.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 14 Sys Screens
571