Figure 145 VDSL PSD Chart Parameter
The following table describes the labels in this screen.
Table 104 VDSL PSD Chart Parameter
LABEL
Break Point
Tone Index
Frequency (kHz)
PSD Level (-
0.5dBm/Hz)
Apply
Cancel
Management Switch Card User's Guide
DESCRIPTION
This index number identifies each incremental break point. You can configure 32 break
points in total. Click the Edit 17 ~ 32 >> link to configure the 17th to 32nd settings.
The frequency range used in VDSL transmission is divided into sub-carriers or tones. Each
tone has a range of 4.3125 kHz.
Enter a value from 0 to 4096 in this field to select a tone. Each Tone Index value must be
higher than that entered in the previous row.
This read-only field displays the frequency equal to the tone index multiplied by 4.3125
dBm/Hz. This field is automatically updated based on the corresponding Tone Index value
entered.
Enter the PSD level in -0.5 dBm/Hz to map to a certain frequency.
Click Apply to save your changes back to the Device.
Click Cancel to begin configuring this screen afresh.
Chapter 9 Subscriber Port Setup Screens
237