Switch Bandwidth Set Command - ZyXEL Communications MSC1000G User Manual

Chapter 33 switch Commands
where
<giga-port>
This command turns on bandwidth control on the specified port(s).
This example turns on bandwidth control for the subtending 2 port.
ras> switch bandwidth enable sub2

33.4.3 switch bandwidth set Command

Syntax:
switch bandwidth set <giga-port> <ingress-rate> <egress-rate>
where
<giga-port>
<ingress-rate>
<egress-rate>
This command sets the incoming or outgoing bandwidth control for the specified port(s).
This example sets the subtending 2 port to only allow 128 Mbps for incoming traffic and 512 Mbps
for outgoing traffic.
ras> switch bandwidth set sub2 128 512
33.4.4 switch bandwidth show Command
Syntax:
switch bandwidth show
This command displays the bandwidth control settings on the Gigabit Ethernet interfaces.
This example displays the bandwidth control settings on the Ethernet ports.
ras> switch bandwidth show
port enable ingress(Mbps)
----- ------ ------------- -------------
sub1 -
sub2 -
up1 -
up2 -
'0' = disable
992
= This represents Gigabit Ethernet uplink ports, subtending ports or all ports. Use
sub1|sub2|up1|up2|all i
t if trunking is enabled.
sub|tup|all
=
This represents Gigabit Ethernet uplink ports, subtending ports or all ports.
Use
sub1|sub2|up1|up2|all i
if trunking is enabled.
sub|up|all
=
The maximum bandwidth allowed in megabits per second (Mbps) for the
incoming traffic flow on a port. Use a number between 1 and 1000.
=
The maximum bandwidth allowed in megabits per second (Mbps) for the
out-going traffic flow on a port. Use a number between 1 and 1000.
egress(Mbps)
0 0
0 0
0 0
0 0
f trunking is not enabled. Use
f trunking is not enabled. Use
Management Switch Card User's Guide