ZyXEL Communications MSC1000G User Manual page 93

Table 19 LAN 2 LAN (continued)
LABEL
Enable
Apply
Cancel
Copy
ID
State
Card Type
Up Time
Firmware
Management Switch Card User's Guide
DESCRIPTION
Select this option to allow the subscriber to allow a DHCP server connected to the specified
DSL port to receive and send DHCP packets through the IES.
Note: Configure this port as a member of a VLAN specific to the LAN-to-LAN connection
before you enable this feature.
Clear this option to stop DHCP query packets from being sent out through this port and
drop DHCP offer packets received from this port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to
display the DHCP Snoop Slot screen where you can view and copy settings from one port
to another port or ports on the selected line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
page 1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
Chapter 4 Access Control List Screens
Section 38.7 on
93