Radius Server Setup - ZyXEL Communications MSC1000G User Manual

Figure 399 Commands Authorization
The following table describes the labels in this screen.
Table 312 Commands Authorization
LABEL
Privilege
Method
Apply
Cancel

14.10.5 RADIUS Server Setup

Use this screen to configure your RADIUS server settings. See
more information on RADIUS servers and
by the authentication and accounting feature on the system. Click the RADIUS Advanced button
in the Sys > AAA screen to view the screen as shown.
Management Switch Card User's Guide
DESCRIPTION
These are the command access levels.
Specify the database the system uses to check whether a user is authorized to execute
commands of the specific privilege level.
Make sure you set up the corresponding database properly before you select a method.
Select none to have the system not perform authorization (authorization will always be
successful).
Select local to have the system use its local database.
Select tacacs+ to have the system use your TACACS+ server.
Select tacacs+ then none to have the system use your TACACS+ server. If the TACACS+
server does not respond, the system does not perform authorization (authorization will
always be successful).
Select tacacs+ then local to have the system use your TACACS+ server and if the
TACACS+ server does not respond, use its local database.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 14.11 on page 587
Chapter 14 Sys Screens
Section 14.10.2 on page 577
for RADIUS attributes utilized
for
581