ZyXEL Communications MSC1000G User Manual page 248

Chapter 9 Subscriber Port Setup Screens
Figure 154 Port > VDSL2: Line Card
The following table describes the fields in this screen.
Table 110 Port > VDSL2: Line Card
LABEL
UP
Copy
Apply
Cancel
Port
Enable
Customer
Information
248
DESCRIPTION
Click this to return to the previous screen.
Do the following to copy settings from one DSL port to another DSL port or ports.
1. Use the Select column to choose a DSL port from which you want to copy settings.
2. Click Copy to display the following screen.
Figure 155 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this screen.
Click Cancel to close the screen without saving changes.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
These are the numbers of the DSL ports on the line card.
To configure advanced port settings, click a port number to display the VDSL Port Setup
screen.
Select a check box in this column to turn on a port. Select the check box at the top of the
column to turn on all of the line card's ports.
Enter information to identify the subscriber connected to this VDSL port. You can use up to
31 printable English keyboard characters (including spaces and hyphens).
Management Switch Card User's Guide