Alarm Commands - ZyXEL Communications MSC1000G User Manual

20.3 alarm Commands

Use these commands to view and clear alarms. You can also set the device to report alarms to an
SNMP or syslog server that you specify.
20.3.1 alarm clear Command
Syntax:
alarm clear
This command erases (clearable) historic alarm entries.
20.3.2 alarm cutoff Command
Syntax:
alarm cutoff
This command cancels an alarm. This stops the sending of the alarm signal current. This is useful in
stopping an alarm if you have the alarm output connector pins connected to a visible or audible
alarm. The alarm entry remains in the system.
20.3.3 alarm edit Command
Syntax:
alarm edit <alarm> <fac> <target>[,<target>]
where
<fac>
<target>
This command creates or edits an alarm report entry.
The following example creates an alarm report entry that sends system alarms to an SNMP server
at the local 3 log facility.
ras> alarm edit sys local3 snmp
20.3.4 alarm history clear Command
Syntax:
alarm history clear [<alarm>|all <condition>|all] <severity>
This command removes historic alarm entries by alarm category, alarm condition or severity.
Management Switch Card User's Guide
=
The log facility (
local1~local7
to different files in the syslog server. See your syslog program's documentation for
details.
=
snmp|syslog|all|none
send (SNMP, syslog or all).
Chapter 20 alarm Commands
) that has the device log the syslog messages
The type of alarm messages that the device is to
disables alarm reports on this alarm category.
none
685