Port Ipbpvc Arpproxy Flush Command - ZyXEL Communications MSC1000G User Manual

Chapter 29 port Commands

29.16.2 port ipbpvc arpproxy flush Command

Syntax:
port ipbpvc arpproxy flush <all | edgerouter [<ip-address> <vid>] | interface [<ip/
mask> <vid>]>
where
all
<ip-address>
<mask>
<vid>
This command clears the specified entries in the Address Resolution Protocol table(s).
29.16.3 port ipbpvc arpproxy show Command
Syntax:
port ipbpvc arpproxy show
This command displays how long the device stores the IP addresses of IP bridge devices in the
Address Resolution Protocol table.
The following is an example.
ras> port ipbpvc arpproxy show
age=300 (sec)
29.17 IP Bridge PVC Commands
Use the port ipbpvc delete, set (see
29.22.5 on page
IP bridge PVCs are similar to regular PVCs and are endpoints of the IP bridge. In addition, IP bridge
PVCs are one of two types, IP over Ethernet or IP over ATM, depending on the underlying network.
The PVID is used to identify the domain the PVC is in, so the PVID must be in a domain.
29.18 port ipbpvc delete Command
Syntax:
port ipbpvc delete <slot-port-vpi/vci>
796
All ARP table entries.
=
IP address, in dotted decimal notation.
=
Number of bits <1..32> in the subnet mask.
=
The ID (<1..4094>) of the VLAN.
=
Section 29.22.4 on page
806) commands to set up and maintain PVCs for subscribers in an IP bridge.
805) and show (see Section
Management Switch Card User's Guide