ZyXEL Communications MSC1000G User Manual page 96

Chapter 4 Access Control List Screens
Table 21 Downstream Broadcast (continued)
LABEL
Delete
Apply
Cancel
Copy
ID
State
Card Type
Up Time
Firmware
96
DESCRIPTION
Select one or more entries' check boxes and then use the Apply button to remove it (or
them). Use the Select All check box to select all of the entries for the specified line card's
port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to
display the Bandwidth Broadcast Slot screen where you can view and copy settings
from one port to another port or ports on the selected line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
page 1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
Section 38.7 on
Management Switch Card User's Guide