Show Ip6 Destination Command - ZyXEL Communications MSC1000G User Manual

Chapter 32 show Commands

32.3.16 show ip6 destination Command

Syntax:
show ip6 destination
This command displays the mapping list of the next-hop address to an IPv6 destination address.
See Section 12.16.3 on page 479
ras> show ip6 destination
Interface: In-band
Destination Address
------------------------------------- -------------------------------------
fe80::213:49ff:fec9:8b5
Interface: Out-of-band
Destination Address
------------------------------------- -------------------------------------
fe80::213:49ff:fec9:8b3
32.3.17 show ip6 neighbor Command
Syntax:
show ip6 neighbor
This command displays the neighbor cache, which lists the MAC addresses of the MSC's interfaces
and neighboring devices. An example is shown next.
ras> show ip6 neighbor
Interface: In-band
Neighbor
------------------------------------- ----------------- --------- --------
fe80::213:49ff:fec9:8b5
Interface: Out-of-band
Neighbor
------------------------------------- ----------------- --------- --------
fe80::213:49ff:fec9:8b3
Flags-state: "Incomplete", "Reachable", "Stale", "Delay",
Flags-IsRouter: "(R)"
954
for more details.
"Probe", "Invalid", "Unknown"
Next Hop Address
fe80::213:49ff:fec9:8b5
Next Hop Address
fe80::213:49ff:fec9:8b3
Linklayer Address Expire
00:13:49:c9:08:b5 permanent Reachable
Linklayer Address Expire
00:13:49:c9:08:b3 permanent Reachable
Management Switch Card User's Guide
Flags
Flags