Profile Alarmadsl Set Command - ZyXEL Communications MSC1000G User Manual

where
<profile>
This command displays the details of the specified alarm ADSL profile or lists all of the alarm ADSL
profiles if you do not specify one.
The following example displays the default alarm ADSL profile (DEFVAL).
ras> profile alarmadsl show DEFVAL
adsl alarm profile : DEFVAL
15MinLofs(lofs)
15MinLoss(loss)
15MinLols(lols)
15MinLprs(lprs)
15MinESs(ess)
15MinFailedFastR(ffr)
15MinSesL(sesl)
15MinUasL(uasl)
FastRateUp(fru)
InterleaveRateUp(iru)
FastRateDown(frd)
InterleaveRateDown(ird) (kbps):
InitFailureTrap(ift)
ras>

30.6.2 profile alarmadsl set Command

Syntax:
profile alarmadsl set <profile> atuc [lofs <lofs>] [loss <loss>] [lols <lols>][lprs
<lprs>] [ess <ess>] [ffr <ffr>] [sesl <sesl>] [uasl <uasl>] [fru <fru>] [iru <iru>]
[frd <frd>] [ird <ird>] [ift <ift>]
or <profile> atur [lofs <lofs>] [loss <loss>] [lprs <lprs>][ess <ess>] [sesl <sesl>]
[uasl <uasl>] [fru <fru>][iru <iru>][frd <frd>] [ird <ird>]
where
<profile>
atuc
atur
<lofs>
<loss>
<lols>
<lprs>
Management Switch Card User's Guide
= The name of an alarm profile.
---------- ----------
(sec):
(sec):
(sec):
(sec):
(sec):
(sec):
(sec):
(sec):
(kbps):
(kbps):
(kbps):
:
=
A name for the alarm profile (up to 31 English keyboard characters).
= Downstream. These parameters are for the connection (or traffic) going from the
IES to the subscriber's device.
=
Upstream. These parameters are for the connection (or traffic) coming from the
subscriber's device to the IES.
=
The number of Loss Of Frame Seconds (0~900) that are permitted to occur within
15 minutes.
= The number of Loss Of Signal Seconds (0~900) that are permitted to occur within 15
minutes.
= The number of Loss Of Link Seconds (0~900) that are permitted to occur within 15
minutes.
=
The Number of Loss of PoweR seconds (0~900) permitted to occur (on the ATUR)
within 15 minutes.
atuc atur
0 0
0 0
0 -
0 0
0 0
0 -
0 0
0 0
0 0
0 0
0 0
0 0
- -
Chapter 30 profile Commands
869