Port Ipbpvc Domain Show Command - ZyXEL Communications MSC1000G User Manual

An example is shown next.
port ipbpvc domain set example

29.19.5 port ipbpvc domain show Command

Syntax:
port ipbpvc domain show [<domain name>]
where
<domain name>
This command displays the settings for the specified domain and the VLAN that are in the domain.
An example is shown next.
ras> port ipbpvc domain show
domain
------------------------------- ----------------------------------------
ISP1
example
The output values correspond to the input values of other IP bridge domain commands.
29.19.6 port ipbpvc domain vlan Command
Syntax:
port ipbpvc domain vlan <domain name> <vid> join|leave
where
<domain name>
<vid>
join|leave
This command adds the specified VLAN to (join) or removes the specified VLAN (leave) from the
specified domain. VLANs in IP bridges share the same VLAN space as regular VLANs, so VLANs in IP
bridges must have different VLAN IDs than regular VLANs. Use the port ipbpvc VLAN command to
configure the VLAN (see
Note: You have to delete every IP bridge setting (including DHCP VLAN) that uses the
selected VLAN before you can remove it from the domain.
In the following example, VLAN 402 is added to domain "example".
ras> port ipbpvc domain vlan example 402 join
Management Switch Card User's Guide
The name of the domain.
=
vid
*101 102
The name of the domain.
=
The ID (<1..4094>) of the VLAN.
=
Specifies whether you want to add the specified VLAN to (join) or remove the
=
specified VLAN from (leave) the domain.
Section 29.29.10 on page
Chapter 29 port Commands
816).
799