Cfm Endpoint Screen: Mip - ZyXEL Communications MSC1000G User Manual

Table 288 CFM Endpoint: MEP (continued)
LABEL
Port
Direction
Priority
CCI-enabled
Modify
Delete

13.19.3 CFM Endpoint Screen: MIP

Click an MA index number in the Switch > CFM > CFM maintenance association screen and
then the MIP tab to display the screen shown next. Use this screen to configure Maintenance
association Intermediate Points (MIPs) under an MA.
Figure 375 CFM Endpoint: MIP
The following table describes the labels in this screen.
Table 289 CFM Endpoint: MIP
LABEL
MD Name
MA Name
Management Switch Card User's Guide
DESCRIPTION
This field displays the end point's physical port on the device.
This field displays whether to send CCMs (Connectivity Check Messages) from the end
point you configured (down) or from (s) (up).
This field displays the priority of the end point.
This field displays the CCMs is sending for the configured end point or not.
Select an end point and click Modify to bring the end point's information shown in this
screen for modification.
Select an end point and click Delete to remove it.
DESCRIPTION
This displays the name of the MD for which you want to configure end points.
This displays the name of the MA for which you want to configure end points.
Chapter 13 Switch Screens
543