Adsl Port Setup Line Card Screen - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
Table 94 ADSL Port Setup (continued)
LABEL
ID
State
Card Type
Up Time
Firmware

9.7.1 ADSL Port Setup Line Card Screen

Click Port > ADSL in the navigation panel to open the ADSL Port Setup screen. Click the slot
number of an active ADSL line card to open the following screen. Use this screen to configure
settings for individual ADSL ports and copy settings between ports.
Figure 131 ADSL Port Setup: Line Card
214
DESCRIPTION
This column lists the slot numbers of the line cards. Click the ID number of an active ADSL
line card to go to a screen where you can copy an ADSL port's settings to another ADSL
port.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
page 1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
Section 38.7 on
Management Switch Card User's Guide