Chapter 2 Hardware Connections
Insert the fiber-optic cables into the transceiver (you may need to remove cable dust covers).
3
Insert the transceiver into the slot with the exposed section of PCB board facing down.
4
Press the transceiver firmly until it clicks into place.
5
Figure 14 Transceiver Installation
Figure 15 Installed Transceiver
2.3.2.5 Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module) from the slot.
Remove the fiber-optic cables from the transceiver.
1
Unlock the transceiver's latch (latch styles vary).
2
Pull the transceiver out of the slot.
3
Put the transceiver's dust cover on the transceiver.
4
Figure 16 Opening the Transceiver Latch
Figure 17 Removing the Transceiver
Console Port
Use the console port for local management of the MSC.
60
Management Switch Card User's Guide