ZyXEL Communications MSC1000G User Manual page 215

The following table describes the fields in this screen.
Table 95 ADSL Port Setup: Line Card
LABEL
UP
Copy
Apply
Cancel
Port
Enable
Customer
Information
ADSL Profile
Mode
Select
Management Switch Card User's Guide
DESCRIPTION
Click this to return to the previous screen.
Do the following to copy settings from one DSL port to another DSL port or ports.
1. Use the Select column to choose a DSL port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 132 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
These are the numbers of the DSL ports on the line card.
To configure advanced port settings, click a port number to display the ADSL Port Setup
screen.
Select a check box in this column to turn on a port. Select the check box at the top of the
column to turn on all of the line card's ports.
Enter information to identify the subscriber connected to this ADSL port. You can use up
to 31 printable English keyboard characters (including spaces and hyphens).
Select a profile of ADSL settings (such as the transfer rate, interleave delay and signal to
noise ratio settings) to assign to this port. Use the ADSL Profile screen to configure
ADSL port profiles.
Select the port's ADSL operational mode. Select the mode that the subscriber's device
uses or auto to have the system automatically determine the mode to use. See
on page 205 for information on the individual ADSL modes.
Use the Select column to choose a DSL port from which you want to copy settings.
Chapter 9 Subscriber Port Setup Screens
Table 87
215