ZyXEL Communications MSC1000G User Manual page 759

Table 364 port Commands (continued)
COMMAND
enet bandwidth
dot3ad
dt
flowctrl
frametype
priority
pvlan
Management Switch Card User's Guide
<slot-port> <ingress-
rate> <egress-rate>
aggport
<slot-port>
t1|t2|...|t10|none
disable <slot>
t1|t2|...|t10
enable
<slot> t1|t2|...|t10
[lacp]
show <slot>
disable <slot-port>
enable <slot-port>
set <slot-port>
<svid> <spriority>
<cvid>
disable <slot-port>
enable <slot-port>
<slot-port> all|tag
<slot-port>
<priority>
delete <slot-port>
<etype>
DESCRIPTION
Sets the incoming or outgoing bandwidth control
for the specified Ethernet (ELC) subscriber port(s)
(0~99968 Kbps).
ingress-rate: The incoming bandwidth rate on a
port.
egress-rate: The outgoing bandwidth rate on a
port.
Creates a link aggregation trunk group for
Ethernet (ELC) subscriber ports.
Turns off link aggregation on the specified
subscriber port trunk group.
Turns on link aggregation on the specified
subscriber port trunk group.
protocol.
Displays Ethernet (ELC) subscriber port link
aggregation settings.
Turns off double tagging on the specified ELC
subscriber port.
Note: These port enet dt commands only
support the GLC1320G-55 line cards.
Turns on double tagging on the specified ELC
subscriber port. The ELC adds two VLAN tags
specified using the command to untagged frames
flowing through the port.
Sets the inner c-tag (customer VLAN tag), the
outer s-tag (service provider VLAN tag), and the
IEEE 802.1p priority level for the s-tag for the ELC
subscriber ports.
Turns off flow control on an ELC subscriber port.
Turns on flow control on ELC subscriber port.
Sets the ELC subscriber port(s) to accept VLAN
tagged and untagged Ethernet frames or only
tagged.
Sets the ELC subscriber port(s) priority (0~7). 0 is
the lowest priority level and 7 is the highest.
Deletes the specified Protocol VLAN membership
entry for a GLC subscriber port.
Etype: This is a number of four hexadecimal digits
that specify the Ethernet type of a specific
protocol. For example, 0806 is the Ethernet type,
0x0806, for ARP (Address Resolution Protocol)
traffic. The system checks for untagged frames
with this Ethernet type.
Note: These port enet pvlan commands only
support the GLC1320G-55 line cards.
Chapter 29 port Commands
P
8
8
8
8
turns on LACP
lacp
1
8
8
8
8
8
8
8
8
759