Radius Screen - ZyXEL Communications MSC1000G User Manual

Chapter 4 Access Control List Screens
Table 32 802.1X PNAC: Port Setup: Slot (continued)
label
Reauthentication
Period (Sec)
Select

4.14 RADIUS Screen

Click ACL > 802.1X PNAC > RADIUS to display the screen shown next.
Figure 50 802.1X PNAC: RADIUS
The following table describes the labels in this screen.
Table 33 802.1X PNAC: RADIUS
LABEL
Enable
Radius Server
1/2
IP address
UDP Port
Shared Secret
Apply
Cancel
114
description
This field displays the IEEE 802.1x re-authentication period.
Select the radio button of the port from which you want to copy settings.
DESCRIPTION
Select this check box to have the switch use an external RADIUS server to authenticate
users.
Enter the IP address of the external RADIUS server in dotted decimal notation.
The default port of the RADIUS server for authentication is 1812. You need not change this
value unless your network administrator instructs you to do so.
Specify a password (up to 31 alphanumeric characters) as the key to be shared between
the external RADIUS server and the system. This key is not sent over the network. This key
must be the same on the external RADIUS server and the switch.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide