ZyXEL Communications MSC1000G User Manual page 986

Chapter 33 switch Commands
Table 386 switch Commands (continued)
COMMAND
show
dscp show
disable
enable
set
garptimer join
leave
leaveall
set
show
isolation disable
enable
vlan
show
lldp enable
disable
txinterval
txhold
reinitdelay <sec>
txdelay
notifyinter
val
986
DESCRIPTION
Sets the time interval between exchanging LACP
timeout short|long
packets.
Displays the link aggregation state.
Displays DSCP-IEEE 802.1p mappings on this
device.
Deactivates DSCP-IEEE 802.1p mappings on this
device.
Activates DSCP-IEEE 802.1p mappings on this
device.
Sets DSCP-IEEE 802.1p mappings on this device.
<srccp> <mapcp>
<mappri>
srccp
1,3~5,10~15.
mapcp: code point, 0~63
mappri: priority, 0~7
Sets the GARP timer's Join Timer (100~32766
<join-msec>
milliseconds).
Sets the GARP timer's Leave Timer in (201~65534
<leave-msec>
milliseconds).
Sets the GARP timer's Leave All Timer in
<leaveall-msec>
(202~65535 milliseconds)
Sets GARP timers.
<join-msec>
<leave-msec>
<leaveall-msec>
Displays the GARP timer settings.
Turns off the subscriber isolation feature.
Turns on the subscriber isolation feature.
Deletes the specified isolation VLAN.
delete <vid>
Creates the specified isolation VLAN.
set <vid>
Displays the subscriber isolation feature's current
setting.
Have the MSC use LLDP to send and get
information about devices connected to its
interfaces.
Turns off LLDP.
Sets the advertised interval (in seconds) the MSC
<sec>
waits before sending LLDP frames.
Sets the time-to-live (TTL) multiplier of the LLDP
<cycles>
frames.
Sets a minimum number of seconds for LLDP to
wait to re-initialize a port that was disabled.
Set the delay (in seconds) between the successive
<sec>
LLDP frame transmissions initiated by value or
status changes in the local system.
Sets the interval (in seconds) between sending
<sec>
notifications due to changes in information about
adjacent devices.
source code point (0~63), for example:
:
Management Switch Card User's Guide
P
8
1
1
8
8
8
8
8
8
8
1
8
8
8
8
1
8
8
8
8
8
8
8