ZyXEL Communications MSC1000G User Manual page 258

Chapter 9 Subscriber Port Setup Screens
Table 114 PVC Setup (continued)
LABEL
Copy
Delete
VPI/VCI
PVID
Profile
MUX
Priority
Mvlan
Enable
usrate limit
(kbps)
usrate limit
Enable
Apply
Cancel
258
DESCRIPTION
Do the following to copy VLAN and PVC settings from one DSL port to another DSL port or
ports.
1. Use the Select column to choose a PVC which you want to copy to another port.
2. Click Copy to open the following screen.
Figure 162 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to clear
all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this screen.
Click Cancel to close the screen without saving changes.
Click Delete to remove the selected PVC.
Type the Virtual Path Identifier and Virtual Circuit Identifier for a channel on this port.
Type a PVID (Port VLAN ID) to assign to untagged frames received on this channel.
This must be the VLAN ID of a VLAN that is already configured. The port that you are
configuring must also be set to the fixed status in the VLAN.
Use the drop-down list box to select an ATM profile to assign to this channel.
Select the encapsulation type (llc or vc) for this channel.
Type the priority value (0 to 7) to add to incoming frames without a (IEEE 802.1p) priority tag.
Select this option to turn on multicast VLAN for this PVC.
Multicast VLAN allows one single multicast VLAN to be shared among different subscriber VLANs
on the network. This improves bandwidth utilization by reducing multicast traffic in the
subscriber VLANs and simplifies multicast group management.
Type the maximum upstream data rate for this PVC.
Select this to limit the upstream data rate to the specified rate above.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide