Entering Parameters - Thermo Scientific Heraeus Megafuge 16 Centrifuge Instruction Manual

4
Operation

Entering Parameters

Entering Parameters
The centrifuge offers you a total of 9 acceleration and 10 braking curves with which samples
and gradients can be centrifuged.
After the centrifuge is turned on, the last running profile selected is shown.
Acceleration curve
1. Press the key
The display shows the message "Set acceleration".
2. Select the profile by pressing the key
Braking curve
1. Press the key
The display shows the message "Set deceleration"
2. Select the profile by pressing the key
Preselecting Speed / RCF
1. Press the key
The display shows the "RPM" or the "RCF"-value depending on the display setting. Press the
CHANGE key
2. Enter the desired value by pressing the key
Note If an extremely low RCF value has been selected, it will be corrected automatically if the
resulting speed is less than 300 rpm.
Heraeus Megafuge 16
4-4
below the ACC display in order to open the acceleration profile selection menu.
, until the desired acceleration curve shows.
below the DEC display in order to open the braking curve selection menu.
, until the desired braking curve shows.
below the "SPEED" display in order to open the speed / RCF value menu.
to toggle between the two modes.
repeatedly, until the desired value shows.
Thermo Scientific