Removing The I/O Module; Figure 34: Snap The I/O Module Into Place (Example); Figure 35: Removing The I/O Module (Example) - WAGO -I/O-SYSTEM 750 XTR Manual

WAGO-I/O-SYSTEM 750 XTR
750-352/040-000 FC ETHERNET G3 XTR
2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 34: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler/controller or
to the previous or possibly subsequent I/O module are established.
Pos : 51.20 /Serie 750 ( WAGO-I/O-SYST EM)/Monti eren/D emonti eren/XTR-I/O-Modul entfernen @ 28\mod_1486551166032_21.doc x @ 405491 @ 3 @ 1
5.6.4

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 35: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Mounting 73
Manual
Version 1.3.0