Removing The End Module; Figure 6: Removing The End Module - WAGO 750 XTR Manual

End module with potential group xtr i/o module for terminating the fieldbus node; with potential group; extreme

Hide thumbs Also See for 750 XTR:

Table of Contents

Mounting

Once the end module has snapped into place, the electrical connection for the

data contacts to the preceding I/O module is established The end module

completes the internal data bus, while providing correct data transmission.

4.2.2

Removing the End Module

Remove the end module from the assembly by pulling the release tab.

The electrical connections for the data contacts are disconnected when removing

the end module. Correct data transmission via the internal data bus is no longer

provided.

Manual

Version 1.0.1

750-600/040-001 End Module with Potential Group XTR

WAGO I/O System 750 XTR

Table of Contents

Table of Contents

750-600/040-001