Removing The I/O Module; Figure 10: Snap The I/O Module Into Place (Example); Figure 11: Removing The I/O Module (Example) - WAGO 750 XTR Manual

66 Mounting

Figure 10: Snap the I/O Module into Place (Example)

3. Check that the I/O module is seated securely on the carrier rail and in the
assembly. The I/O module must not be inserted crooked or askew.
Once the I/O module has snapped into place, the electrical connections for the
data contacts and power contacts (if any) to the head station or to the preceding
and, if applicable, following I/O module are established.
6.2.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 11: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Manual
Version 1.0.0
WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR