Figure 86: Codesys - New Module Has Been Generated; Figure 87: Codesys - Enter The Event In A Global Variable - WAGO 750-8207 Manual

248 Run-time System CODESYS 2.3
Figure 86: CODESYS – New Module has been Generated
Handling for the event that has occurred is now programmed in this new function.
In the example here, the event is documented in a global variable.
Figure 87: CODESYS – Enter the Event in a Global Variable
The newly created project is now supported and can be loaded to the controller.
After startup, the value of the "Events" variable changes only when counter "i"
reaches the value 0, meaning that division by 0 has been performed.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G