Configuration Of Plc Runtime Services" Page; General Configuration" Group; Codesys 2" Group; E!Runtime" Group - WAGO 750-8207 Manual

142 Commissioning
7.8.1.26

"Configuration of PLC Runtime Services" Page

The settings for various services of the activated runtime system are shown on
the "Configuration of PLC Runtime Services" page.

7.8.1.26.1 "General Configuration" Group

Table 84: WBM "Configuration of PLC Runtime Services" Page – "General Configuration" Group
Parameter
Port Authentication
Password
Confirm Password
Click [Submit] to apply change. The change is effective immediately.

7.8.1.26.2 "CODESYS 2" Group

Table 85: WBM "Configuration of CODESYS Services" Page – "CODESYS 2 Web Server" Group
Parameter
CODESYS 2 State
Web server enabled
Communication enabled
Communication Port
Number
Port authentication enabled
Click [Submit] to apply change. The change is effective immediately.

7.8.1.26.3 "e!RUNTIME" Group

Table 86: WBM "Configuration of CODESYS Services" Page – "e!RUNTIME Web Server" Group
Parameter
e!RUNTIME State
Web server enabled
Port authentication enabled
Click [Submit] to apply change. The change is effective immediately.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
Specify the new password for port authentication.
Enter the new password again for confirmation.
Explanation
This displays the status (enabled/disabled) of the
CODESYS 2 runtime system.
Enable or disable the CODESYS 2 web server for
the CODESYS web visualization here.
Enable or disable the communication between the
CODESYS 2 runtime system and the CODESYS 2
programming system.
Enter here the port number for communication with
the CODESYS 2 programming system. Default
value is 2455.
Define here whether port authentication is enabled.
If this is enabled, the password specified under
"General Configuration" must be entered when
logging in via CODESYS 2 IDE.
Explanation
This displays the status of the e!RUNTIME system
(enabled/disabled).
Enable or disable the e!WEBSERVER for the
e!RUNTIME web visualization here.
Enter here whether a login is required for connecting
to the device. The user name is admin and the
password specified at "General Configuration."
WAGO-I/O-SYSTEM 750