Show Interface Ethernet - Cisco Nexus 7000 Series Reference Manual

show interface ethernet

show interface ethernet
To display the Energy Efficient Ethernet (EEE) status on an interface, Use the show interface command.
Syntax Description
slot/chassis
Defaults None.
Command Modes Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.1(2)
Usage Guidelines This command does not require a license.
Examples This example shows how to display the EEE status on an interface:
switch# show interface ethernet2/6
Ethernet2/6 is down (Link not connected)
admin state is up, Dedicated Interface
Hardware: 10000 Ethernet, address: 0022.5579.de41 (bia 001b.54c1.af5d)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, medium is broadcast
auto-duplex, auto-speed, media type is 10G
Beacon is turned off
Auto-Negotiation is turned off
Input flow-control is off, output flow-control is off
Auto-mdix is turned off
Rate mode is shared
Switchport monitor is off
EtherType is 0x8100
EEE (efficient-ethernet) : n/a
Last link flapped never
Last clearing of "show interface" counters never
0 interface resets
30 seconds input rate 0 bits/sec, 0 packets/sec
30 seconds output rate 0 bits/sec, 0 packets/sec
Load-Interval #2: 5 minute (300 seconds)
Cisco Nexus 7000 Series NX-OS System Management Command Reference
514
show interface ethernet slot/chassis
Slot or chassis number. The range is from 1 to 253.
Modification
This command was introduced.
Show Commands
OL-25806-03