Ntp Source - Cisco Nexus 7000 Series Reference Manual

ntp source

ntp source
To configure the Network Time Protocol (NTP) source, use the ntp source command. To remove the
NTP source, use the no form of this command.
Syntax Description addr
Defaults None
Command Modes Global configuration mode (config)
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure the NTP source:
switch(config)# ntp source 192.0.2.3
This example shows how to remove the NTP source:
switch(config)# no ntp source 192.0.2.3
Related Commands Command
show ntp source
Cisco Nexus 7000 Series NX-OS System Management Command Reference
312
ntp source addr
no ntp source addr
IPv4 or IPv6 address of the source. The IPv4 address format is dotted decimal,
x.x.x.x. The IPv6 address format is hex A:B::C:D.
Modification
This command was introduced.
Description
Displays information about the NTP source.
N Commands
OL-25806-03