R Commands
record netflow
To select a traditional Layer 2 record for the NetFlow monitor, use the record netflow command. To
remove the record selection, use the no form of this command.
Syntax Description
layer2-switched
input
Defaults
None
Command Modes
NetFlow monitor configuration
Supported User Roles
network-admin
vdc-admin
Command History
Release
4.0
Usage Guidelines
This command does not require a license.
Examples
This example shows how to select a traditional Layer 2 record for the NetFlow monitor:
switch(config)# flow monitor FLowMonitor1
switch(config-flow-monitor)# record netflow layer2-switched input
switch(config-flow-monitor)#
This example shows how to remove the traditional Layer 2 NetFlow record selection:
switch(config-flow-monitor)# no record netflow layer2-switched input
switch(config-flow-monitor)#
Related Commands
Command
record
record netflow-original
OL-25806-03
record netflow layer2-switched input
no record netflow layer2-switched input
Specifies the traditional Layer 2 NetFlow collection scheme.
Specifies the input NetFlow.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
Description
Specifies a flow record to be used by a NetFlow monitor.
Selects an input IPv4 record.
record netflow
349