Ntp Server - Cisco Nexus 7000 Series Reference Manual

ntp server

ntp server
To configure a Network Time Protocol (NTP) server, use the ntp server command. To remove the NTP
server, use the no form of this command.
Syntax Description ip-address
ipv6-address
dns-name
key
key-id
prefer
use-vrf
vrf-name
Defaults None
Command Modes
Global configuration mode (config)
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(1)
Usage Guidelines
Make sure that you are in the correct virtual device context (VDC). To change the VDC, use the switchto
vdc command.
If you configure a key to be used while communicating with the NTP server, make sure that the key exists
as a trusted key on the device.
This command does not require a license.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
310
ntp server {ip-address | ipv6-address | dns-name} [key key-id] [prefer] [use-vrf vrf-name]
no ntp server {ip-address | ipv6-address | dns-name} [key key-id] [prefer] [use-vrf vrf-name]
IPv4 address.
IPv6 address.
Domain Name Server (DNS) name.
(Optional) Specifies the key to be used for associating with a server.
Key ID. The range is from 1 to 65535.
(Optional) Specifies the given NTP server as the preferred one.
(Optional) Specifies the virtual routing and forwarding (VRF) name.
VRF name. The VRF name can be default, management, or any case-sensitive,
alphanumeric string up to 32 characters.
Modification
This command was introduced.
N Commands
OL-25806-03